I was able to plug the standard 34-pin floppy cable that I had into the planar's (motherboard's) 40 pin connector using only the last 34 pins, and the other side into the Gotek emulator. I know the Gotek has some jumper settings as well.īasically, does anyone know what jumper settings need to be used in order to make a standard floppy drive work on a later-model IBM PS/2 Model 80?įrom there, I downloaded the IBM PS/2 Model 70/80 Reference Disk from this site. However, the site mentions the need to change jumper settings on the standard floppy drive to get it to work properly. As usual, the OEM floppy drive that it has seems shot (I've already cleaned the heads), and I might try to do a repair of the capacitors some time, but in the interim, I'd like to use a Gotek floppy emulator that I have to get something going.Īccording to this site, it is possible to use a standard floppy drive with the PS/2 if you just use a conventional floppy cable and power the drive off the PSU with a molex to floppy power adapter. I have already replaced the CMOS battery, but now I need to boot a reference disk, and update the CMOS settings to get it working. But the Gotek has let me keep installing DOS without need for the original disks anymore.I am trying to rescue an IBM PS/2 Model 80 (8580-A21) that uses the standardish 34-pin floppy drive connector with power. I've personally transfered some MS DOS install discs to a USB drive to let me install dos on a bunch of old computers - previously, in the last several years, I've actually gone through a ton of DOS install sets that I'd have to buy on ebay because inevitably a disk or two would fail. These are basically the equivalent of an Everdrive for many old computers. The gotek hardware is even moddable, there are pinouts on the board inside the unit for a piezo speaker you can solder on to make the emulator "click" while reading the disk images, like real floppies did. They connect using an IDE ribbon cable just like any other 3.5" floppy drive. They currently work on MSX computers, x86 computers, Atari ST computers, Amiga Computers, Amstrad computers, apple computers, and even things like the FM Towns Marty. What's awesome is how many different types of computers these work on. A large LCD panel on the unit tells you which floppy drive image is currently "inserted." But the main gist is that they let you turn a USB drive into a "book" of multiple floppy disks which can be mounted and unmounted using the buttons on the drive. When you put a USB drive into the gotek floppy emulator, depending on the firmware and type of computer you are using it on, it reacts a few different ways. They emulate 360 kb, 720kb, and 1.44 mb 3.5" floppy drives through a USB thumb drive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |